maximum distortion
英 [ˈmæksɪməm dɪˈstɔːʃn]
美 [ˈmæksɪməm dɪˈstɔːrʃn]
网络 最大畸变; 最大失真
双语例句
- Therefore, study of how to ensure the accounting information authenticity and how to prevent the maximum extent accounting information distortion has important practical significance.
因此，研究如何保证会计信息的真实性，如何在最大范围内防止会计信息失真，具有重要的现实意义。 - New Method for Designing Maximum Output Level and Calculating Distortion Index of CATV Amplifiers
有线电视放大器最高输出电平设计和失真指标核算新方法 - The results of theoretical analysis show that the low energy resolution reduces sharply the peak reflectivity of Mo/ Si multilayer but increases the background intensity, which leads to the increase of the full width of half maximum of reflectivity spectrum and the distortion of reflectivity spectrum.
理论分析发现这两种因素对Mo/Si多层膜反射率影响完全不同：入射光低的单色性不但极大降低Mo/Si多层膜峰值反射率，而且使反射曲线的半峰全宽增加； - The estimation of the maximum instantaneous distortion at the outlet of inlet
进气道出口最大瞬时畸变值的预估 - Based on the experimental result, the influence of the maximum tensile stress and distortion energy density on brittle fracture and crack opening direction is analyzed by means of studying the field of distortion energy density and principal stress in the vicinity of a crack tip.
分析了裂纹尖端附近的形状改变能密度场和主应力场，结合试验数据研究了最大拉应力与形状改变比能对脆性断裂及断裂方向的影响。 - Determination of Maximum Distortion in a Horizontal Reactor by Equation of Deflection Curve
以挠曲线方程确定卧式反应器最大变形量 - The maximum distortion and distortion angle between payload mounting plate and ground under 4 kinds of operational modes with high/ low temperature and aluminum/ carbon coat plane were acquired, and so were the thermal distortion pictures of the satellite and the Y-direction.
给出了高/低温、铝合金/碳纤维蒙皮四种不同工况的整星最大变形和有效载荷安装板对地变形角，并由此得到了整星和有效载荷板Y向的热变形图。 - Problem of filter position in the prediction of maximum instantaneous distortion
最大瞬时畸变预测中的滤波位置问题 - Under this condition that the peak value is nearly equal to the value of the mid-frequency range of the closed-loop gain, a method of calculation for the optimum value of the negative feedback depth ( that is the maximum value at no TIM distortion) is found out.
在这个突峰值近似地等于这个闭环增益中频段的数值的情况下，找到了计算负反馈深度最佳值，即无瞬态互调失真（TIM失真）的最大值的方法。 - Estimation of the maximum instantaneous distortion with correlated fluctuation pressures
脉动压力相关时最大瞬时畸变值的预估 - The Influence of the Maximum Principal Stress and Distortion Energy Density on Fracture
最大主应力与形状改变比能对断裂的影响 - It is very important that antenna target support structure and rigidity during antenna precision measurement in microwave darkroom. Based on the precision effect and requirement, when structure suffered to maximum load, relationship of parameter between structure and distortion was provided.
介绍了在微波暗室里进行天线精度测量的基本原理，从结构受最大载荷变形后对天线测试台精度的影响这一角度出发，给出了结构参数和变形与整体刚度之间的关系。 - Specimens of human cornea were tested in uniaxial tension experiment. It's ultimate strength, maximum distortion energy and its density are determined.
对人角膜标本进行了单轴拉伸实验，测定了其极限强度、应力最大时的变形能及其变形能密度； - An improved method for prediction of maximum total pressure distortion
改进的畸变极值预测法 - Then the statistical relation between the number of measured samples, the measurement period and the maximum value of distortion are determined. The paper also presents the 121 type computer program and the results of calculation.
明确了测试样元数，测试时间与畸变最大值之间的统计关系，并给出121机计算程序与计算结果。 - The statistical properties and maximum value of instantaneous distortion caused by Gaussian fluctuating pressure
脉动压力为正态分布时瞬时畸变的随机统计特性及其最大值的预估 - A method is presented to build the wavelet coefficient set which can embed watermark information. The bit is inserted in the high activity texture regions with the maximum strength of Just Noticeable Distortion ( JND) tolerance of Human Visual System ( HVS).
提出可嵌入水印的小波系数集生成方法，扩展了基于视觉系统（HVS）小波域量化噪声的视觉权重（JND）分析方法，使其适用于DEM数据，并能够自适应地确定水印嵌入的强度。 - The application of maximum distortion energy theory in the calculation of the total strength of machines elements
最大形变能理论在机械零件整体强度计算中的应用 - When the mean correlation coefficient, defined in this paper, is less than 0.1, at different condition the relative error of estimated values are less than 3%, the maximum value of instantaneous distortion can be estimated by an assumption of uncorrelated fluctuation pressures.
≤0.1时，不同条件下估算值相对误差均小于3%，这时可不考虑脉动压力相关。 - This paper have analyzed the maximum output voltage amplitude and distortion of the three basic amplifier circuits by using the graphical method.
用图解法分析了放大电路三种基本组态的最大输出电压幅值Uomax及其失真现象。 - In this paper a method of predicting the maximum distortion IDC and IDR of the the outlet flow field of the intake is presented. As in the instantaneous IDC, the minimum value of the total pressure distributed along a ring is involved;
提出了一种预估流场畸变指数IDC、IDR瞬时最大值的方法。 - The speech understanding will not be depressed provided that the maximum relative time shift between different frequency components due to phase distortion is less than 20 ms.
只要相位失真带来的不同频率分量之间的最大相对时移小于20ms，就不会影响对连续语音的正常理解。 - The maximum pressure distortion in the inlet surface increases with the stator moving to the right then has decreasing tendency.
随着静子叶片右移，在进口截面处最大压力畸变逐渐增大，之后呈下降趋势； - During the whole compression process, the characteristic of maximum compression pressure and minimum distortion restitution force of grass piece in the different position of compression chamber had distinct difference. Though the above two forces occurred in every compression process, however, they had the essential difference.
压缩全过程草片在压缩室各个位置上的最大压缩力与最小变形恢复力的特性存在明显的差异，这是因两个力虽然在每次压缩时均出现，但存在本质区别造成的。 - Prediction and experiments of maximum instantaneous distortion index of IDC and IDR
瞬时畸变指数IDC、IDR最大值的预估与实验 - If eccentric pump center is 0.6 mm, the maximum thermal distortion is reduced by 31.3%.
偏心0.6mm时，端面最大热形变量减少31.1%。 - Electrode installation location should as far as possible in front, and intermediate conduit maximum limit signal distortion.
电极安装位置应尽量在中间过水管前端，可最大程度保证所测信号与所在深度的同步性。 - They start with an analytical solution, followed by a nonlinear optimization technique based on the maximum likelihood criterion. Finally, they take into account lens distortion, giving both analytical and non-linear solutions.
其首先定义一个分析方案，然后利用基于最大可能性准则进行非线性优化，最后考虑到镜头畸变，给出分析结果和非线性解。